|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-30-2014, 05:30 PM
|
#1 |
|
Registered User
Join Date: Jan 2010
Location: Forsyth, Ga
Posts: 1,012
|
Bench seat mounting hole locations...
Anyone have a quick diagram or some measurements for the bolt holes that hold down the bench seat on this series truck. I have some seats to put in that are said to line up directly with the bench holes but my ride is a Suburban which uses a different setup. Any help greatly appreciated.
|
|
|
|
06-30-2014, 07:58 PM
|
#2 |
|
Moderator
 Join Date: Dec 2012
Location: ON, Canada
Posts: 2,156
|
Re: Bench seat mounting hole locations...
I just went through this. The PO of my truck had cut the bolts off flush with the floor. You can see where they go from the bottom, there are little rectangular reinforcements welded to the floor pan. I simply placed the seat in, lined up the old bolt pieces, made marks, and drilled straight through the old bolts. Bolt and nut to mount the seat. Could have tapped, but didn't bother.
|
|
|
|
|
07-01-2014, 09:38 AM
|
#3 |
|
Registered User
Join Date: Nov 2011
Location: fayetteville nc
Posts: 10,338
|
Re: Bench seat mounting hole locations...
I have a gutted cab right now. I can get measurements tonight if needed.
__________________
1963 Short bed step side SBW 427 big block and borg warner T-16 HD 3 speed manual http://67-72chevytrucks.com/vboard/s...d.php?t=519869 1963 Short bed fleetside BBW 348 1st gen big block w/Powerglide http://67-72chevytrucks.com/vboard/s...d.php?t=619024 1964 Short bed trailer |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
