|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-09-2014, 10:26 PM
|
#1 |
|
Registered User
Join Date: Aug 2012
Location: Neskowin OR
Posts: 1,153
|
Quick u-joint question
What u-joint does the stock 12-bolt take? I had my driveshaft shortened and had new u-joints installed, but the guy put the wrong u-joint on. I'm guessing a '69 truck 12 bolt from a 1/2 ton would all have the same sized u-joint. Looks like it should be 3 5/8" wide? I'm talking at the pinion yoke where it attaches with the straps.
Thanks Al |
|
|
|
07-09-2014, 10:41 PM
|
#2 |
|
Registered User
Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,229
|
Re: Quick u-joint question
If it fits the driveshaft but not the flange you will probably need a conversion joint. It has different dimentions on each side.
|
|
|
|
|
07-09-2014, 10:44 PM
|
#3 | |
|
Registered User
Join Date: Aug 2012
Location: Neskowin OR
Posts: 1,153
|
Re: Quick u-joint question
Quote:
|
|
|
|
|
|
07-10-2014, 12:58 AM
|
#4 |
|
Registered User
Join Date: Jun 2011
Location: United States
Posts: 159
|
Re: Quick u-joint question
Most likely the pinion yoke is a 1310
|
|
|
|
|
07-10-2014, 03:06 AM
|
#5 |
|
Registered User
Join Date: Aug 2012
Location: Neskowin OR
Posts: 1,153
|
Re: Quick u-joint question
Just measured the width and it's 3.625 or 3 5/8. Definitely a 1330. Not sure if that's standard for a 12-bolt, guess they could have either.
|
|
|
|
|
| Bookmarks |
|
|
<- My daughter loves this guy 8-)
Linear Mode
