1971 K20 LS 5.3L Swap issue headers

[67Steven]

I am running DT headers and I did need to clearance the frame, just a small scallop on each side, but I reinforced the inside area, no problems so far.

[DWilbur]

Originally Posted by 67Steven

I am running DT headers and I did need to clearance the frame, just a small scallop on each side, but I reinforced the inside area, no problems so far.

I checked out your build thread a couple of time it looks like your engine sits about 1 higher than mine. so the DT headers fit better. your using an auto transmission. I still have problems with the hydraulic clutch bracket that is molded in to the bell housing I would like to use.