Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
07-17-2014, 07:56 AM | #1 |
Registered User
Join Date: Dec 2011
Location: Belgium
Posts: 82
|
Gap for the headliner retainer
Can someone please measure the gap where you put the rubber retainer to hold/finish the headliner ?
Mine is between 3mm (1/8) and 11mm (7/16), so I would like to know what it should be ... Thx, Wim
__________________
'56 Chevy stepside shortbed SBC350 - TH350 12-bolt rear |
07-17-2014, 04:56 PM | #2 |
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Gap for the headliner retainer
Sounds about right if you are talking about between the lip for the rubber and cab roof. The are not on a parallel arc. I know I am installing fabric on a backer and tried a 1/4 board and it would not slide into some of the area. 1/8" will work, I am using door edge molding to trim it out after the fabric is in.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
07-18-2014, 03:15 AM | #3 | |
Registered User
Join Date: Dec 2011
Location: Belgium
Posts: 82
|
Re: Gap for the headliner retainer
Quote:
I thought it had to be parallel ... Thx for the feedback !
__________________
'56 Chevy stepside shortbed SBC350 - TH350 12-bolt rear |
|
07-18-2014, 12:25 PM | #4 |
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Gap for the headliner retainer
Back home, here are mine. Corner is about 3/16" , sides 1/4" front and back center about 3/8".
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
07-18-2014, 02:37 PM | #5 |
Registered User
Join Date: Jan 2012
Location: Motown
Posts: 7,680
|
Re: Gap for the headliner retainer
parallel not required the rubber hides all the imperfections.
i had similar gaps as orrieg's roof, by the time i glued 1/8'' foam and material on the roof i could not get the rubber in. with the stock headliner you can use soapy water to lube the roof, headliner and lip not so with ultrasuede, i destroyed a new rubber trying to get it in i ended up using the above mentioned door edge trim
__________________
cool, an ogre smiley Ogre's 58 Truk build how to put your truck year and build thread into your signature shop air compressor timer |
07-22-2014, 09:29 AM | #6 |
Registered User
Join Date: Dec 2011
Location: Belgium
Posts: 82
|
Re: Gap for the headliner retainer
Many thanks OrrieG and _Ogre for the feedback !
__________________
'56 Chevy stepside shortbed SBC350 - TH350 12-bolt rear |
Bookmarks |
|
|