|
04-10-2012, 10:54 AM
|
#1 |
|
Registered User
Join Date: Jun 2007
Location: The West
Posts: 767
|
tube straightener
Getting ready to fabricate fuel and brake lines for our project.
The 3/8" Stainless Steel line arrived from Summit. Wow, I can tell this is going to be hard to work with. I want to purchase a tube straightener and have been searching for the best pricing. Jegs has it for $199. Anybody found this tool for less? |
|
|
|
04-20-2012, 09:30 PM
|
#2 |
|
Registered User
Join Date: Jan 2012
Location: Motown
Posts: 7,680
|
Re: tube straightener
The kit I got from inlinetube.com had 5 pieces of 3/16" straight tube.
It would be cheaper to buy a new kit from them than to deal with coil stock Posted via Mobile Device
__________________
cool, an ogre smiley  Ogre's 58 Truk buildhow to put your truck year and build thread into your signature shop air compressor timer |
|
|
|
|
04-24-2012, 08:56 PM
|
#3 |
|
Registered User
Join Date: Jun 2006
Location: Indiana
Posts: 4,859
|
Re: tube straightener
How are you going the double flare the SS line? The kits that can work SS are not cheap, but then you may already have a dedicated bench top flaring press.
__________________
'70 GMC C1500 LWB Power disc brakes. WooHoo! Posi 6 Lug Dana 60 |
|
|
|
|
04-25-2012, 12:02 AM
|
#4 |
|
Registered User
Join Date: Jun 2007
Location: The West
Posts: 767
|
Re: tube straightener
Brake lines will not be SS but made with mild steel. Just as they are on the 69 FB we built lines for, with a hydroboost system. I will do them with a 45 degree flare. No problem.
Fuel lines require 37 degree flare. To use with AN fittings. I will do those as well. Thanks for your help with my original question |
|
|
|
|
07-30-2014, 11:27 PM
|
#5 |
|
Registered User
Join Date: Oct 2007
Location: hopewell jct new york
Posts: 140
|
Re: tube straightener
jegs miss printed the price in the july - august catalog i just got it for 103.99 buy it up i am stoked
|
|
|
|
|
07-31-2014, 09:29 AM
|
#6 |
|
Registered User
 
Join Date: Jul 2010
Location: Mesa, AZ
Posts: 513
|
Re: tube straightener
It is super easy to straighten out the coiled tubing. All you need is a length of 2x4 and a couple pairs of hands. Straighten the coil mostly by hand, just get it close. Then you and buddy (my wifey helped me), roll the tubing between garage floor and the 2x4. I takes a bit of time, but you will get a very straight piece. A 2x6 would make it even easier as the rolling distance would be longer and you wouldn't have to reset the board as much. Good luck.
__________________
JB from AZ 1969 Chevy Sub K10 1957 Chevy 3200 1962 VW Beetle 1957 Willys CJ5 
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
