|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-09-2014, 07:45 AM
|
#1 |
|
Registered User
Join Date: May 2012
Location: Falls Church, Virginia
Posts: 65
|
Door hinge pin removal
Any advice on getting the pins out of the door hinges? PB Blaster, vise, and a hammer aren't getting it done. Don't have a torch. Thanks
|
|
|
|
08-09-2014, 07:12 PM
|
#2 |
|
Registered User
Join Date: May 2014
Location: Kewanee IL
Posts: 283
|
Re: Door hinge pin removal
3 of my 4 came apart as should 4th one I took to work (did it on my breaks) and milled it out. I then got a bigger pin and bushings for it
|
|
|
|
|
08-09-2014, 07:23 PM
|
#3 |
|
Registered User
Join Date: Jun 2004
Location: El Lago, TX
Posts: 1,668
|
Re: Door hinge pin removal
I don't have specific experience with 60-66 trucks, but on other years if you cut the pin right in the middle with a cut off wheel they come right out once they are broken into two pieces.
|
|
|
|
|
08-09-2014, 08:25 PM
|
#4 |
|
Registered User
Join Date: Jun 2013
Location: Somewhere
Posts: 3,069
|
Re: Door hinge pin removal
Not sure on earlier years, but I think 67-72 are staked on the bottom. Grind off the rounded head rather than the staked end and drive out with a drift.
Soak them in ATF for a few days. Put them in your oven for an hour at the highest temp. You can get a propane torch for sweating copper at the home store for a few bucks. Heat the hinge, not the pin. Send it to me, I'll get it out.  Just a few ideas. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
