The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 08-16-2014, 02:08 PM   #1
Squareforceone
Registered User
 
Squareforceone's Avatar
 
Join Date: Nov 2010
Location: Rustville USA or southeast Ia
Posts: 654
Hard starting?

I have no idea what's going on here. I put a new motor in my 84 and ever since have had nothing but problems.. Motor is a 357 and it seems to run good but it starts terrible it never likes to start after it's been ran awhile it just turns over dead slow. I've checked the initial timing, put on a heat sheild to protect the starter from the headers and still the same problem. I thought the battery maybe the cause as the one that's in it was junk but nope and heres where i get confused. I took a brand new battery out of my daily driver and put it in the truck and it did the same thing. Put it back in my daily and it wouldn't start that either my truck had totally drained the battery. I'm stumped.
__________________
Rust is better than rice.
Squareforceone is offline   Reply With Quote
Old 08-16-2014, 02:49 PM   #2
donut
Registered User
 
donut's Avatar
 
Join Date: Aug 2009
Location: S.C.
Posts: 1,593
Re: Hard starting?

You checked the timing and it's good... Care to share?
Back off the timing and try again.

The '73 had too much timing. It actually liked running more, but more than 14* it would be slow to crank, if it caught, the starter would backlash. Trial and error to see where that would happen.

If you back off the timing and it still acts like this, (assuming the cables are new and not in question) pull the starter and get it tested.
__________________
'86 C-30 dually, 454/tbh400
'73 K-20 350/350/205 (sold )

I'm kinda like duct tape- no real purpose, but handy to have around.
donut is offline   Reply With Quote
Old 08-16-2014, 02:56 PM   #3
Squareforceone
Registered User
 
Squareforceone's Avatar
 
Join Date: Nov 2010
Location: Rustville USA or southeast Ia
Posts: 654
Re: Hard starting?

trust me i have messed with the timing plenty backed off i have had that distributor in every possible place. it is not the timing. Besides timing would of drained a brand new battery in 20 minutes of driving.
__________________
Rust is better than rice.
Squareforceone is offline   Reply With Quote
Old 08-16-2014, 05:18 PM   #4
86c20
Registered User
 
86c20's Avatar
 
Join Date: Mar 2012
Location: edgartown mass
Posts: 852
Re: Hard starting?

1. test starter 2. check alt. low charge will be slow crank. 3. if they are stock calbes go to a 4? next size or two up. they where to small from factory. also check your grounds. and check them again and again. best to have the neg at the starter
__________________
1986 c20 "the hillbilly" 350 sm465 3.42gears 21mpg at 70mph
1985 k30 "the ice cream truck from hell" no rust az truck
197-8??? c30 "ramp truck" 454
1978 monte carlo 350 350th with 2.73 gears. no rust. sc car
86c20 is offline   Reply With Quote
Old 08-16-2014, 06:07 PM   #5
donut
Registered User
 
donut's Avatar
 
Join Date: Aug 2009
Location: S.C.
Posts: 1,593
Re: Hard starting?

Quote:
Originally Posted by Squareforceone View Post
trust me i have messed with the timing plenty backed off i have had that distributor in every possible place. it is not the timing. Besides timing would of drained a brand new battery in 20 minutes of driving.
Drained the new battery in 20 min of driving? Does the alternator even work?
I thought we were fighting a starting problem, maybe a charging problem?

What does the alt gauge read?
__________________
'86 C-30 dually, 454/tbh400
'73 K-20 350/350/205 (sold )

I'm kinda like duct tape- no real purpose, but handy to have around.
donut is offline   Reply With Quote
Old 08-17-2014, 12:02 PM   #6
Corts60
Just here to tinker
 
Corts60's Avatar
 
Join Date: Jun 2008
Location: Holland, MI
Posts: 3,697
Re: Hard starting?

You should have the following grounds:
Battery to engine
Battery to body
Engine to body
Engine to frame
Battery to frame

The battery to engine cable should be at least 4 gauge and all the others should be a 10 or 12 gauge wire.
Corts60 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:23 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com