How many wires in the doors?

[JohnKimble]

I'm out of town and away from the truck or else I'd check. I'm going to be pulling both doors and planning on splicing in a male/female connector for the wires in each door to make future removal easier.

The truck is an '85 with power windows and power locks.

Thanks

[blazer2007]

There is alot,but up in the corners by the kick panels they have 2 plug in conecters on each side that you can unplug but I think you have to take off the rubber boots between the door and cab and the ones I saw were riveted on

[JohnKimble]

Oh I didn't know there were already connectors. My plan was to splice some in so I could easily take the doors off without cutting the wires. If there are already connectors there, then I don't need to worry about it!

[blazer2007]

They a little bit of work getting to them if you have air,all the duct work

[motornut]

Originally Posted by blazer2007

There is alot,but up in the corners by the kick panels they have 2 plug in conecters on each side that you can unplug but I think you have to take off the rubber boots between the door and cab and the ones I saw were riveted on

only time I get to use this pic.lol
the inside door pic dosn't show the two PL wires below
be sure to check the wire colours match up,some may move in the plug

[blazer2007]

That was nice of you to pull out the fender just to take a pic.

[motornut]

Originally Posted by blazer2007

That was nice of you to pull out the fender just to take a pic.

lol