The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-21-2014, 09:36 PM   #11
clinebarger
Senior Member
 
Join Date: May 2009
Location: Fort Worth, TX
Posts: 6,370
Re: 700R4 build thread.

Flip the Drum over.

Replace the 4 Teflon Sealing Rings on the Input/Turbine shaft.
Use the One Piece Sealing Rings ONLY, Use Scarf cut or Step cut at your own risk!!!!

These are difficult to install without Installer & Resizing tools.
There are several DIY methods on the internet/YouTube, Some pointers....

Do not over stretch the Seals, Just enough to go on without damage.

Do not Under Size them either! Using hose clamps & what not, Just get them small enough to lightly rock the Stator shaft on them.

Install the selective shim & Torrington Bearing on the Input Drum, Slide the Stator Shaft down the Input Shaft to do Final Sizing.

Always resize 1 Sealing ring at a time, Start with the Bottom Ring First!

The Stator Shaft is bolted to the Pump Body, Use Pump Body/Stator Shaft assembly for Final Sizing.....Just to be clear.

Another option is taking the Input Drum to a trans shop for Sealing Ring Install.

1st pic, My install tool.

2nd pic, Found on the internet using a Lip Wizard
Attached Images
  
clinebarger is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:10 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com