|
08-21-2014, 08:45 PM
|
#1 |
|
Registered User
Join Date: Mar 2014
Location: Middletown, Connecticut
Posts: 44
|
Ho 52 housing swap
Hi I've posted on here in the past about HO 52 swaps. I'm planning on doing it over this weekend and was wondering if the full floater eaton needed to be shimmed. If so any method recommendations?
Thanks Andrew |
|
|
|
08-22-2014, 11:23 AM
|
#2 |
|
Registered User
Join Date: Jan 2007
Location: Topeka,KS
Posts: 778
|
Re: Ho 52 housing swap
If you're just changing the jug, no.
__________________
68' C20. 283CI w/55CC 305HO heads, NP435 Close Ratio, Corp. 14 bolt FF 3.21, 75' front end swap (everything but the X-member). |
|
|
|
|
08-23-2014, 10:48 AM
|
#3 |
|
Registered User
Join Date: Mar 2014
Location: Middletown, Connecticut
Posts: 44
|
Re: Ho 52 housing swap
Haha I don't know exactly what you mean by jug, but my plan is to pull the rear drive shaft and unbolt the 4:56 ring and pinion as one then slid the 4:10 set I have back in its place.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
