S10 Swap how to

[CaliforniaDaddy]

Originally Posted by skymangs

Next is the placement of those cab stands.

Front cab stands - measure 2 1/8th" forward of the oval frame hole just behind the flare of the frame (right behind front wheel). Scribe a vertical line. This will mark the rear edge of the front cab stand.

Rear cab stands - measure 10 1/2" from the rear of the 5/8" round frame hole, or 33 1/4" behind the rear edge of the front cab stand. Scribe a vertical line, this will be the front edge of your rear cab stand.

Note. If you are putting together a longbed (123" wb.) use the 33 1/4" measurement for your rear cab stand.

just want to make sure this applies to 117.9 in (2,995 mm) (reg. cab long bed chassis) I have a 1996 Chassis.