PO has me PO'd

[jaros44sr]

Thanks for the EXCLUSIVE, ok folks you saw it here first. I thought i would like them, and i do. Still working out how to do it to 4WD.
Just thought that being in close proximinty to the wheel, the heat may cause damage to the tire bead, but im sure you covered all your bases

As far as the bed goes, i removed all the sheetmetal.PITA! Two crossmembers were rusty, so i had to replace them. One was the rear, and bought a 73 and later piece. It just happened to have a 3/4" notch in it that fit my wood perfectly,even had the holes in the proper location for the SS ribs, then just layed it on the front step up, and it was all level.

Had to enlongate the mounting holes and use fender washers on the wheel houses as they were now 3/4" higher, and moved the two seams up to match up again, but that was easy, as i just flattened them and rebent were needed.

When this oak fails, as im sure it will, i ll be putting a plastic in, as you suggest, or ipe

If you do it, i ll be here to answer your questions

Not sure if you can pull off door panels and glove box door in wood, seen it done and did nt look right, unless you do it like RR, and use a veneer, serious craftmenship at that company