68 S/C update.....

[Hart_Rod]

Originally Posted by mikentosh

Love the build! Any updates on getting cruise working with the LS3?

Thanks. I bought a Rostra module and with the help of a boardmember, made it work.

Originally Posted by slowcpe

So how are the new shocks treating you?

I really like them. I'm currently waiting on Moser to send me some new axles to replace the incorrectly machined ones that I originally purchased from them. The bad axles were causing a vibration that I have been chasing for a while now. Once I get them swapped out, I'll be doing some more road testing with the shocks, .

[chevyguy_72]

Originally Posted by Hart_Rod

Thanks. I bought a Rostra module and with the help of a boardmember, made it work.

Something like this?
http://www.summitracing.com/parts/rpc-250-2316
More details would be great if possible... I am about to work on this same thing...
Thanks

[Hart_Rod]

Originally Posted by chevyguy_72

Something like this?
http://www.summitracing.com/parts/rpc-250-2316
More details would be great if possible... I am about to work on this same thing...
Thanks

I'm not familiar with that kit. We used kit 1858, it's for a DBW. I'm sure there are other kits that will work (possibly 1848), but I'm not sure. The biggest hurdle we had was converting the 4K PPM o/p signal from the computer to an 128K PPM i/p signal that the 1858 was looking for. After that, the only other issue I had was with LED tail lights.

[chevyguy_72]

Originally Posted by Hart_Rod

I'm not familiar with that kit. We used kit 1858, it's for a DBW. I'm sure there are other kits that will work (possibly 1848), but I'm not sure. The biggest hurdle we had was converting the 4K PPM o/p signal from the computer to an 128K PPM i/p signal that the 1858 was looking for. After that, the only other issue I had was with LED tail lights.

Resistance issues or something to that effect?

[Hart_Rod]

Originally Posted by chevyguy_72

Resistance issues or something to that effect?

Yes. The lights worked great without a resistor, but there wasn't enough resistance to allow the CC to "latch". When I put a factory bulb back in, the CC worked fine. I just need to add a relay to the CKT and then I can put the LED tail lights back in.