5.3 swap in K5, need new fuel tank for 2003 fuel evap system

[93FatBottom]

Originally Posted by BigRed76

The pressure sensor doesn't have to be mounted directly on the tank. It can be anywhere in the evap line between the tank and the charcoal canister, because the evap line will have the same pressure as the tank.

Would you by chance have any examples or ideas of a quick cheap easy way to mount the sensor?

[BigRed76]

Originally Posted by 93FatBottom

Would you by chance have any examples or ideas of a quick cheap easy way to mount the sensor?

I think the simplest way would be to find a section of the EVAP line between the tank and the canister that is rubber, and tee into that rubber line with vacuum tees or something similar and then have the teed hose go right onto the nipple of the fuel tank pressure sensor.

If you're planning on using the factory charcoal canister up under the hood then it may be easiest to put the sensor up near the canister, that way the wiring for the sensor can be a lot shorter and help simplify your engine wiring harness.

[chebyshortbox65]

I have got one through smog in one of the toughest counties in california riverside county pm me