|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-07-2015, 10:37 PM
|
#1 |
|
Registered User
Join Date: Sep 2014
Location: Tallahassee, Florida
Posts: 21
|
Question on wheels and tires
I'm doing a frame off resto-mod on a 1982 GMC, SWB, FLEETSIDE. Lowering on a 2/4 retaining the 15" rims in front and have a pair of 15x10 for the rear. Can I use 245x60r15 in front and 295x50r15 on the rear without rubbing issues?
I'm sure this question has been asked and answered at k east once, but I am unable to locate. Thanks for any advise. |
|
|
|
01-08-2015, 12:53 AM
|
#2 |
|
Registered User
Join Date: Aug 2012
Location: Clovis, NM
Posts: 2,705
|
Re: Question on wheels and tires
You should be fine with that setup. Front tire may even seem too small with only a 2 inch drop.
__________________
2018 Audi S5- wife's ride 1980 Chevy Scottsdale http://67-72chevytrucks.com/vboard/s...d.php?t=543511 1981 Chevy Silverado- in pieces 1964 Chevy c10 2017 Jeep Wrangler JKU |
|
|
|
|
01-08-2015, 10:16 AM
|
#3 |
|
Parts and more parts
Join Date: Nov 2003
Location: Lebo, Kansas (middle of nowhere
Posts: 6,821
|
Re: Question on wheels and tires
I ran that same tire combo on my trucks for years, but I had a 3" drop in the front and a 4" drop in the rear. The only thing you have to watch is that the rear side of the rim may rub on the lower A-arm and you would have to shve some metal off of the arm to clear the wheel weights.
__________________
Frank |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
