|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-14-2015, 03:27 AM
|
#1 |
|
Registered User
Join Date: Mar 2014
Location: Elko, nevada
Posts: 286
|
Alluminum heads/headers/intake question
What alluminum heads would be a nice street setup for a 89 Silverado 350? And headers to go with it and intake?
|
|
|
|
01-14-2015, 04:18 AM
|
#2 |
|
Registered User
Join Date: Feb 2009
Location: slurrey, bc.
Posts: 1,134
|
Re: Alluminum heads/headers/intake question
are you keeping the tbi?
__________________
-'73 c/10 - Low with Go - will be complete... probably never. -'90 2wd Blazer - well... soon enough anyways. -'84 SWB - the daily gas guzzler. |
|
|
|
|
01-14-2015, 03:39 PM
|
#3 |
|
Registered User
Join Date: Mar 2014
Location: Elko, nevada
Posts: 286
|
Re: Alluminum heads/headers/intake question
Not sure on that, if I did swap it out would I have to mess with the computer? If I leave it on what is needed?
|
|
|
|
|
01-14-2015, 07:52 PM
|
#4 |
|
driving is in my blood
Join Date: Dec 1999
Location: Mesa AZ
Posts: 5,763
|
Re: Alluminum heads/headers/intake question
Your asking for alot of info, and there is no single answer to what's "best". You need to decide what route you want to take with the truck before picking out hard parts.
__________________
-78 c10 short/step: 388cid, M20, 5/5 drop, lots more. Playtoy and first vehicle. -98 c1500 x-cab: 5.7L, 17" rims, 5/6 drop, flowmaster, helper bags,NBS rear disk brakes. -02 Suburban 4x4: leveled front -CBR600F4i, CBR600RR, CBR1000RR, and standup skis DISCLAIMER: I cant spell for the life of me. |
|
|
|
|
01-14-2015, 08:40 PM
|
#5 |
|
Registered User
Join Date: Aug 2012
Location: Northeast KS
Posts: 1,803
|
Re: Alluminum heads/headers/intake question
vortec heads, dual plane intake(for tbi or for 4bl carb with tbi adapter), long tube headers, 212/218ish cam. enjoy awesome bottom end power.
__________________
1999 GMC Suburban K2500 SLT, 454/4L80E 1991 Z/28, 6.0L/T56 1949 GMC 250, S10 Frame, 6.0L/4L80E Instagram @aceshighspeedshop |
|
|
|
|
01-15-2015, 01:29 AM
|
#6 |
|
Registered User
Join Date: Mar 2014
Location: Elko, nevada
Posts: 286
|
Re: Alluminum heads/headers/intake question
I was looking at edelbrock intake rpm air gap with some edelbrock heads, what headers would fit without modifying? I know some have clearance issues
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
