|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-24-2015, 04:29 PM
|
#1 |
|
Registered User
Join Date: Nov 2012
Location: ravenwood, mo
Posts: 709
|
quick bolt hole question
I'm putting a 73+ crossmemember under a 68 frame and need a little guidance. a few of the bolt holes didn't quite line up, so I elongated them with a carbide bit. Now the holes in the frame are much bigger than the bolt. Should I weld a hardened washer to the inside of the frame to shrink the hole? I was thinking I would weld a washer to the inside of the frame and then fill the excess hole in on the other side. Then grind smooth. Is this the right idea?
|
|
|
|
| Bookmarks |
|
|
Linear Mode
