|
02-18-2015, 08:23 PM
|
#1 |
|
Registered User
Join Date: Apr 2014
Location: Williamston SC
Posts: 45
|
H.E.I question
I am replacing my points distributor on my 70 307 with an hei unit. I have already replaced the resistor wire and currently running the point feed thru a resistor. Gonna remove resistor to give coil full 12 volts. now my question is does anyone know if 8mm wires will fit into the factory 7mm wire retainers to run wires back under the manifolds or do i need to get some corvette wire retainers to fit the 8mm plug wires?
|
|
|
|
02-18-2015, 08:45 PM
|
#2 |
|
Registered User
 
Join Date: May 2013
Location: Sacramento, CA
Posts: 487
|
Re: H.E.I question
I didn't have a problem with the fit on mine.
__________________
Rich J. 1967 Chevy C20 Longbed Stepside w/283 and 4spdSOLD  2002 Chevy Tahoe 4X4 5.3L SOLD 2015 Chevy Silverado Crew 4X4 5.3L |
|
|
|
|
02-18-2015, 08:53 PM
|
#3 |
|
Registered User
Join Date: May 2010
Location: Wisconsin & Arizona
Posts: 4,854
|
Re: H.E.I question
Mine were tight, but they fit. These are the Bosch version of the Vette wires.
|
|
|
|
|
02-18-2015, 09:12 PM
|
#4 | |
|
Registered User
Join Date: Jun 2014
Location: Glendale, Arizna
Posts: 1,642
|
Re: H.E.I question
Quote:
|
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
