|
03-31-2015, 06:39 PM
|
#1 |
|
Registered User
Join Date: Oct 2011
Location: Houston tx
Posts: 701
|
Column shifter swap
 Any idea of how hard it is to swap out the factory shifter to a billet? A buddy said it's easy and all I gotta do is remove the pin and swap them out.. Tried the search option but no luck... Thanks |
|
|
|
03-31-2015, 08:18 PM
|
#2 |
|
Registered User
Join Date: Mar 2015
Location: Phoenix
Posts: 13
|
Re: Column shifter swap
Use a hammer and a punch to knock the pin on the stock shifter where the shifter mounts to the collar on the column. Super simple.
|
|
|
|
|
03-31-2015, 08:51 PM
|
#3 |
|
Registered User
Join Date: Oct 2011
Location: Houston tx
Posts: 701
|
Re: Column shifter swap
I did that and sure was super simple.. This shifter input shaft is to short so back to the drawing board!! Gonna take the factory shifter and figure out a way to use that shaft that goes into the column on the billet shifter.. Either machine it down or weld it
|
|
|
|
|
03-31-2015, 10:25 PM
|
#4 |
|
laying low
 
Join Date: Mar 2001
Location: Searcy, Ark. USA
Posts: 13,535
|
Re: Column shifter swap
Do you have a tilt column? The shift levers are different between a tilt and non tilt column. I think that looks like a tilt column shift lever.
__________________
Boog 69 Chevy stepside, 358/T350, 4.11 posi, 4.5/4 drop, rallys, poboy driver primer is finer 91 Chevy sportside, Tahoe, Yukon & GMC Crewcab All GM..'nuff said. I stand for the flag and kneel at the cross |
|
|
|
|
03-31-2015, 10:42 PM
|
#5 |
|
Registered User
Join Date: Oct 2011
Location: Houston tx
Posts: 701
|
Re: Column shifter swap
No I don't have a tilt column.. I should be able to install it in the next few days.. Gonna see what my buddy who's a machinist can figure out
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
