|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-31-2015, 08:33 PM
|
#1 |
|
Registered User
Join Date: May 2013
Location: Altadena, CA
Posts: 25
|
Upper Door Hinge problem - swing-open limiter pulling thru
On '67 C10... Pass door has been swung all the way open too many times. Upper hinge where limiter/stopper located is pulling through on inside bolt. Outside two bolts still have some sheet metal around them. I think I'll be cutting an access hole in front of window reg is and forming a piece to fit across and trying to weld it in, inside the door.
I've been searching and don't see a trick for this. Just wondering if you had advice and what worked or what was overkill. |
|
|
|
03-31-2015, 08:35 PM
|
#2 |
|
Registered User
Join Date: May 2013
Location: Altadena, CA
Posts: 25
|
Re: Upper Door Hinge problem - swing-open limiter pulling thru
Dadgum that one was sideways. And iPhone not doing two at once. Here's inside area and it contour that I have to fit.
|
|
|
|
|
04-06-2015, 09:13 PM
|
#3 |
|
Registered User
Join Date: May 2013
Location: Altadena, CA
Posts: 25
|
Re: Upper Door Hinge problem - swing-open limiter pulling thru
This was very tricky to reach in with welder and try to see what I was doing. But still easier than changing door.
|
|
|
|
|
04-06-2015, 09:14 PM
|
#4 |
|
Registered User
Join Date: May 2013
Location: Altadena, CA
Posts: 25
|
Re: Upper Door Hinge problem - swing-open limiter pulling thru
Why the heck all my pics turning sideways when I upload? This site and Siri don't jive?
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
