|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
05-01-2015, 08:28 AM
|
#1 |
|
Registered User
Join Date: Dec 2012
Location: Pendleton, Indiana
Posts: 235
|
Re: anyone else have one corner set down after drop
Tri5 have you measured four points to the bottom of the frame to rule out body mounts? Just a thought.
Rick |
|
|
|
05-01-2015, 11:21 AM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,144
|
Re: anyone else have one corner set down after drop
Did you measure each corner before lowering? Chances are it might have had the issue before but wasn't noticed because the larger gaps make it less obvious.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
05-01-2015, 07:45 PM
|
#3 |
|
Registered User
Join Date: Jan 2014
Location: Germantown ohio
Posts: 47
|
Re: anyone else have one corner set down after drop
Body mounts are good I checked that, frame is good. Yes scotti it was off some before as well
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
