|
05-29-2015, 11:16 AM
|
#1 |
|
Registered User
Join Date: May 2015
Location: Saskatoon
Posts: 84
|
Stubborn Ball Joint
Installing a 2/4 drop on my 67 and cannot get the driver's side ball joint out. Passenger came out with a couple hits but driver's will not budge. Have tried a sledge and separator. Any tips?
|
|
|
|
05-29-2015, 10:33 PM
|
#2 | |
|
The Older Generation
   
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,404
|
Re: Stubborn Ball Joint
Quote:
Not sure unless you can use some heat on it. I can't remember if you can get to the spindle where the stud goes through it or not. I will have to check one of mine in the morning. Stay tuned.... LockDoc
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - |
|
|
|
|
|
05-29-2015, 10:40 PM
|
#3 |
|
Registered User
Join Date: Oct 2008
Location: Marianna Arkansas
Posts: 7,262
|
Re: Stubborn Ball Joint
You may need a ball joint press. Those help a bunch on stubborn ball joints. It is a matter of removing the spindle and setting up the press then pressing it out. Most all parts store will have one to loan or rent. [that is one thing that the online stores cant do] Jim
|
|
|
|
|
05-29-2015, 10:50 PM
|
#4 |
|
Registered User
Join Date: Jan 2007
Location: Puyallup, WA
Posts: 1,660
|
Re: Stubborn Ball Joint
I just did this. I had to use two pickle forks on the drivers side upper ball joint for it to pop.
__________________
72 C10 lwb fleetside -stock 350/350 combo |
|
|
|
|
05-30-2015, 09:10 AM
|
#5 |
|
Registered User
Join Date: May 2013
Location: Centerville,Ma.
Posts: 1,223
|
Re: Stubborn Ball Joint
If you are talking about getting the tapered part of the ball joint out of the spindle whacking the spindle with a 3 pound hammer should do it. If not hold a hammer behind the spindle while hitting it. To get the ball joint out of the control arm a ball joint press will do it without damaging the control arm. I have a pickle fork in my tool box that hardly ever gets used since I was shown how to hit the spindle to remove.
|
|
|
|
|
05-30-2015, 12:19 PM
|
#6 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Stubborn Ball Joint
I've had to take a sawzall to it when it was stuck on my 71c10 after tryin everything i knew to try for two days cut right thru it and tossed the spindel
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
