|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-12-2015, 10:58 AM
|
#1 |
|
Registered User
 
Join Date: Nov 2013
Location: Roseville, CA
Posts: 207
|
Rear bumper lineup, Stepside
Dead center of tailgate & dead center of bumper don't line up. About a inch off.
Also the ends of the bumper seems to roll down to much. I wonder if this is a problem with the after market type bumpers. Trying to even the bumper ends with the rear fenders, Any stepsiders run into this ??? |
|
|
|
06-12-2015, 11:06 AM
|
#2 |
|
Senior Member
Join Date: Sep 2007
Location: Albuquerque NM
Posts: 7,862
|
Re: Rear bumper lineup, Stepside
subbed. im almost to the part of puttin on my bumpers as well
__________________
1967custom |
|
|
|
|
06-12-2015, 11:41 AM
|
#3 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Rear bumper lineup, Stepside
is the rear end centered with an adjustable panhard bar?
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
06-12-2015, 12:05 PM
|
#4 |
|
Registered User
Join Date: Nov 2013
Location: Roseville, CA
Posts: 207
|
Re: Rear bumper lineup, Stepside
Hanging a weighted sting from the center of the tailgate to the back center of the license plate holder on the bumper we are a inch off
|
|
|
|
|
06-12-2015, 12:12 PM
|
#5 |
|
Registered User
Join Date: Jun 2015
Location: Denver, co
Posts: 66
|
Re: Rear bumper lineup, Stepside
I would start by measuring bed side to side off the frame, then the bumper side to side with the frame. That should start to narrow down the problem.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
