Marvin (1953 3100)

[solidaxel]

Originally Posted by GeorgeR

I'm doing a very similar A/C install with the new Vintage Air Gen. IV system. I am running my hoses behind the fender and up through the access panel also. I had planned on using bulkheads in the removable access panel but now that I have the bulkheads and the evaporator installed, I see there is not enough room. running the hoses straight to the evap. works but I haven't figured out a good way to seal off the hoses in the access panel yet. Have you fabricated a solution to this yet? Would greatly appreciate if you could share.
Thanks,
George Rust
'49 GMC

By the time you get your 5 hoses and a wire or two in there, there is not much room left to seal up