Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
09-01-2015, 02:05 AM | #14 | |
Registered User
Join Date: Nov 2013
Location: Sebastopol California
Posts: 151
|
Re: Dana 44 closed knuckle disc brake conversion
Quote:
I haven't done this yet myself but researched it enough I think I can answer you questions. Some of your questions depend on 3/4 ton or 1/2 ton. 1. Yes off a dana 44 with disc brakes 6 lug or 8 depending on what you have. 2. Yes that's why the spindle must be replaced. Again I don't think it matters just a dana 44 again 6 or 8 lug. 3. Yes it needs to be turned down to fit the needle bearings. 4. Depends on the year of you truck. If it's 67-69 you could just use what they used on the newer models that came with disc brakes. If your truck is a 60-66, look up Capt. Fab for your answer. If you still have a single master clyinder be prepared to bend some new brake lines. 5. I've never used anything but 90w in both my closed knuckle 44s with no issues. Hope that helps |
|
Bookmarks |
|
|