|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-16-2004, 12:29 AM
|
#1 |
|
Registered User
Join Date: Jan 2003
Location: Medicine Hat, Alberta,Canada
Posts: 64
|
Front dif. pinion depth setting
Need help to set my pinion depth. Anyone got a way to start from scratch to figure out what shims should be used without one of them fancy factory tools few people actually have. opened my dif up and there were too many shims on outer pinion shaft, and some back yard fixer didn't even use any carrier shims so I am starting fresh.
__________________
1970 Longhorn, factory air & Cruise,Tach vac 1970 C 20 3/4 4x4 350 with turbo 350 auto, |
|
|
|
02-16-2004, 06:41 PM
|
#2 |
|
Account Suspended
Join Date: Nov 2003
Location: Oregon
Posts: 300
|
What kind of axle is it?
|
|
|
|
|
02-18-2004, 12:14 AM
|
#3 |
|
Registered User
Join Date: Jan 2003
Location: Medicine Hat, Alberta,Canada
Posts: 64
|
Sorry for lack of information
Differential is a Dana 44 front on my 70 3/4 4x4. sure could use some help.
__________________
1970 Longhorn, factory air & Cruise,Tach vac 1970 C 20 3/4 4x4 350 with turbo 350 auto, |
|
|
|
|
02-18-2004, 01:07 AM
|
#4 |
|
Account Suspended
Join Date: Nov 2003
Location: Oregon
Posts: 300
|
On a 44 I always start with 40 thousands under the pinion and then go from there. They usually end up at 35-45 thousands.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
