The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1947 - 1959 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 10-13-2015, 08:28 PM   #1
74project
Registered User
 
Join Date: May 2009
Location: Las Vegas
Posts: 216
Bucket seat height on 54 ???? thanks

hello does anyone have buckets that could measure there bucket seat height? I picked up Buckets out of my friends 66 Nova...
Attached Images
 
74project is offline   Reply With Quote
Old 10-14-2015, 03:35 AM   #2
crossfire84
Registered User
 
crossfire84's Avatar
 
Join Date: Jun 2012
Location: wind lake WI
Posts: 1,747
Re: Bucket seat height on 54 ???? thanks

there is no set height, each person is different. you want to set your height so your line of site is set to the middle of the windshield.
__________________
LIL ERV the 50-3600
396 BBC stroked to 415 cid
Richmond 6spd over drive
C4 rear
Porter built a arms
Never give the Devil a ride,because he'll want to Drive!
crossfire84 is offline   Reply With Quote
Old 10-14-2015, 12:39 PM   #3
mr48chev
Registered User
 
mr48chev's Avatar
 
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,389
Re: Bucket seat height on 54 ???? thanks

From past experience that style of bucket seat doesn't work well in and AD truck unless you are pretty short legged. I only have a 30 inch inseam and the seat was too far forward to be comfortable when it sets right with the lean back sitting as it is designed to.

You usually want the cushion up about level with that the original cushion was at though or you are sitting too low for the steering wheel if you have a stock column.
__________________
Founding member of the too many projects, too little time and money club.

My ongoing truck projects:
48 Chev 3100 that will run a 292 Six.
71 GMC 2500 that is getting a Cad 500 transplant.
77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around.
mr48chev is offline   Reply With Quote
Old 10-14-2015, 01:33 PM   #4
OrrieG
Registered User
 
OrrieG's Avatar
 
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
Re: Bucket seat height on 54 ???? thanks

Not ad but here is how I set mine, tape line is window sill, I wanted my arm to be comfortable. Note eye line is about center of windshield too. I am short so even stock height always seemed low. Make sure you have the steering column and wheel in place to judge the front to back clearance too. I had 68 Camaro buckets in one of my cars and had the same issue as mr48, pinched my hamstrings. Traded them out for a caddy bench.
Attached Images
 
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread
1964 Chevelle Malibu w/ 355-350TH (daily driver)
Helpful AD and TF Manual Site Old Car Manual Project
OrrieG is offline   Reply With Quote
Old 10-14-2015, 03:40 PM   #5
capnduane
Registered User
 
capnduane's Avatar
 
Join Date: Jan 2014
Location: Moreno Valley, Calif.
Posts: 244
Re: Bucket seat height on 54 ???? thanks

I have buckets in my 55 2nd, nearly the same as yours, mine are out of a 66/67 Chevelle. They are comfortable for me, and I am 6'2" and 225lbs. Here's some numbers from my setup. Seat is 12 1/2ins from floor. Seat back is just at rear window bottom (small window). Front of seat is 15ins from brake pedal. Seat back is 13 1/2ins from steering wheel. And steering wheel is 8 1/2ins above seat. Leg room is adequate, altho brake and clutch could be about 1in further away. And my beer gut just clears original steering wheel. A smaller wheel would help, but would make steering harder. If you have power steering, no problemo!
Attached Images
 
__________________
'55 Chevy 1/2ton pickup w/ Pontiac 350 and Muncie M21 close ratio 4speed "Red Ryder"

Last edited by capnduane; 10-14-2015 at 03:54 PM.
capnduane is offline   Reply With Quote
Old 10-14-2015, 05:38 PM   #6
_Ogre
Registered User
 
_Ogre's Avatar
 
Join Date: Jan 2012
Location: Motown
Posts: 7,677
Re: Bucket seat height on 54 ???? thanks

Quote:
you want to set your height so your line of site is set to the middle of the windshield.
that is relative too, at 6'4'' that would have my butt on the floor
my seat is higher than orrieg's, my line of sight is near the top of the windshield and the back of my head is over the top of the back window
all in a quest to get more legroom

(drinking a **beer while driving around the track at indy)

** empty
__________________
cool, an ogre smiley Ogre's 58 Truk build

how to put your truck year and build thread into your signature
shop air compressor timer
_Ogre is offline   Reply With Quote
Old 10-14-2015, 05:51 PM   #7
capnduane
Registered User
 
capnduane's Avatar
 
Join Date: Jan 2014
Location: Moreno Valley, Calif.
Posts: 244
Re: Bucket seat height on 54 ???? thanks

Pbr?
__________________
'55 Chevy 1/2ton pickup w/ Pontiac 350 and Muncie M21 close ratio 4speed "Red Ryder"

Last edited by capnduane; 10-14-2015 at 06:15 PM.
capnduane is offline   Reply With Quote
Old 10-14-2015, 06:08 PM   #8
dsraven
Registered User
 
Join Date: Nov 2010
Location: calgary alberta
Posts: 7,903
Re: Bucket seat height on 54 ???? thanks

that seat back height is usually why a lot of guys have short back seats, so they can get the seat back far enough so their legs aren't cramped up.
dsraven is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:17 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com