|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
11-03-2015, 12:03 PM
|
#1 |
|
Never Ending Projects
Join Date: Jul 2006
Location: San Diego, CA
Posts: 3,836
|
Re: New HBalancer is coming off! What did I do wrong?
That is correct 7/16 fine thread. It's the same as a SBC bolt and washer. I took one off an old engine I had but any of the aftermarket ones work.
If the balancer came off by hand, even if the snout looks "fine" it likely wore it down a few thousands. Since it relies on a interference fit (i.e. the snout is slight larger than the hole in the balancer), the Loctite and bolting it might not be enough to keep it from moving slightly. You're definitely going to have to tap it. Good luck!
__________________
. 1965 C10 Panel,  Tiki Express http://www.67-72chevytrucks.com/vboa...d.php?t=506580 SOLD1968 Chevy C10, Long, Fleetside, Hot Rod Hauler http://67-72chevytrucks.com/vboard/s...d.php?t=313233 SOLD 1965 Chevy C10, Long, Fleetside, Hot Rod C10 http://67-72chevytrucks.com/vboard/s...d.php?t=415702 SOLD We were given two ears and one mouth for a reason... listen twice as much and speak half as often... |
|
|
|
| Bookmarks |
|
|
Hybrid Mode
