|
11-16-2015, 06:03 PM
|
#1 |
|
Registered User
Join Date: Jan 2015
Location: San Diego cA
Posts: 2
|
1970 C15 SBC Oil Pan
I am building a engine for my 1970 C15. I did not measure the clearance I had between my cross-member and oil pan before i pulled it. Can someone help me with what the clearance is. I want to order a 8qt pan with windage installed. Thanks in advance for any help or advice given.
|
|
|
|
11-17-2015, 01:14 AM
|
#2 |
|
Registered User
Join Date: Jul 2013
Location: Winnsboro Texas
Posts: 367
|
Re: 1970 C15 SBC Oil Pan
Here is a bump for ya. I figured someone out there would know this.
You have a stock pan you can measure to compare how much more room you need? Or I remember I can measure one of my trucks tomorrow if you need.
__________________
The bitterness of poor quality lingers long after the sweetness of a low price is forgotten. |
|
|
|
|
11-17-2015, 01:56 AM
|
#3 |
|
Registered User
Join Date: Jan 2015
Location: San Diego cA
Posts: 2
|
Re: 1970 C15 SBC Oil Pan
i know a stock pan is 3.5 inches from the bottom of the front of the block down; then slopes down. The one I want to purchase is 4.5. I wish I had measured. Thanks for your reply
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
