Picture of Jack Handle and Tire Tool on fender well 81-78

[tucsonjwt]

As I recall, my 77 had the same set up as the picture of my 83 in the second post above. My 83 picture shows a 3/4 ton jack, but I have since replaced it with a 1/2 ton jack because the 3/4 ton jack would not work.

[philobeddoe]

Ok, that'll be fine then, tha

[sanjac272]

I'd like to buy a set if anyone knows of one. 1978 GMC

[tucsonjwt]

I would check the pick and pull, but they usually remove the jack before the vehicle goes out on the lot to prevent people from jacking up the vehicles. Ebay often has used jacks, but make sure that the one you get actually works.

[philobeddoe]

I have tried a jeep jack and a ford jack, both look very similar, but no way will fit properly. I have tried placing the jack many different ways. I do have the correct mounting brackets, front and back of wheel well. And...my jack instructions sticker is still in good shape, so I was using that to make sure I had proper placement. Guess i'll have to get a 70's chevy truck jack from ebay or something. Thanks all for the pics and replys.

[1970pelle]

Great timing on this, I'm at the point of reinstalling these items on my truck. ,I failed to tag the bolts that hold the tools down. There different lengths. Thanks for the photo's.


Ken