Nik's 62 build - The 1947 - Present Chevrolet & GMC Truck Message Board Network

62stepside longbox · 12-31-2015, 04:01 AM

Quote:

Originally Posted by TJ's Chevy

Good work on getting it out of there. lol Hey talk about sore...I carried my 292 inline 6 block from the car to the machinist bench. lol!

So this is how all the chiropractors are becoming so rich

**TJ's Chevy** · 12-31-2015, 11:10 AM

Quote:

Originally Posted by 62stepside longbox

so this is how all the chiropractors are becoming so rich

haha!

62stepside longbox · 12-31-2015, 09:48 PM

Picked up my t5 today. Jeep 10 spline input shaft, shortened pilot tip and shortened bearing retainer, S10 tail housing so shifter is in correct location for a bench seat. OD gear is 0.76

62stepside longbox · 12-31-2015, 09:48 PM

02

12-31-2015, 09:48 PM	#3
62stepside longbox Registered User Join Date: Aug 2015 Location: Kelowna, B.C, Canada Posts: 1,747	Re: A 15 year old's project. Rusty 62 stepside Picked up my t5 today. Jeep 10 spline input shaft, shortened pilot tip and shortened bearing retainer, S10 tail housing so shifter is in correct location for a bench seat. OD gear is 0.76 Attached Images __________________ Nik...................____ 62 lwb c10 step-side 261 5 spd .........________//__{\_____ ,,,,,,,/__(O)___//___/__(O)_/ my build thread. Sending unit solution

12-31-2015, 09:48 PM	#4
62stepside longbox Registered User Join Date: Aug 2015 Location: Kelowna, B.C, Canada Posts: 1,747	Re: A 15 year old's project. Rusty 62 stepside 02 Attached Images __________________ Nik...................____ 62 lwb c10 step-side 261 5 spd .........________//__{\_____ ,,,,,,,/__(O)___//___/__(O)_/ my build thread. Sending unit solution



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.