|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-19-2015, 09:34 PM
|
#1 |
|
go cyclones
Join Date: Jun 2003
Location: Ames, IA
Posts: 1,885
|
lokar ED-5002 dipstick will not fit
So i ordered a ED-5001 for my blazer with a GM crate 350 that i purchased in 2001. I noticed that it was the wrong one when i looked at the block, so i ordered a ED-5002 for a pre-1979 block. The hole on my crate engine is too small. I went to try it on my original engine that sitting on my stand and it fit right on.
Why would a gm crate engine have a different hole dimension for the dip on a crate motor? Or am am doing something wrong? Thanks, |
|
|
|
11-30-2015, 08:03 PM
|
#2 |
|
But Found Her 25yrs Later!
Join Date: Oct 2010
Location: Oregon City, Oregon
Posts: 10,526
|
Re: lokar ED-5002 dipstick will not fit
Did you ever find an answer?
__________________
I lost my 65 - Found it 25 years later: http://67-72chevytrucks.com/vboard/s...d.php?t=426650 66 C20 Service Truck: http://67-72chevytrucks.com/vboard/s...d.php?t=428035 |
|
|
|
|
11-30-2015, 11:45 PM
|
#3 |
|
Registered User
 Join Date: Jul 2015
Location: 2nd left past the stump on a dirt road.
Posts: 2,629
|
Re: lokar ED-5002 dipstick will not fit
Not to be upsetting to ya, but so many parts.........so little time.
That remind ya of something, to me the aftermarket gets scrutinized to great extent. |
|
|
|
|
02-01-2016, 12:25 AM
|
#4 |
|
go cyclones
Join Date: Jun 2003
Location: Ames, IA
Posts: 1,885
|
Re: lokar ED-5002 dipstick will not fit
Yes I figures it out. I borrowed a pin gauge set and was finally able to determine there was years of build up on the lip if the hole. After rigging up some interesting handles to a fine round file I was able to clean it out enough to put the tube it. If it wasn't for the pin gauge set I still would have been scratching my head.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
