|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-11-2016, 08:24 PM
|
#1 |
|
Registered User
Join Date: Sep 2014
Location: The Dalles OR
Posts: 123
|
Starting up a rebuilt 350 motor for the first time
 What needs to be done ?
|
|
|
|
02-11-2016, 08:46 PM
|
#2 |
|
Registered User
Join Date: Apr 2014
Location: Bloomington Indiana
Posts: 1,041
|
Re: Starting up a rebuilt 350 motor for the first time
Same as for a new crate engine. Here's the GM instructions, starting in the middle of page 3.
https://www.chevrolet.com/content/da...e-12499529.pdf
__________________
Rich Weyand 1978 K10 RCSB DD. |
|
|
|
|
02-11-2016, 10:24 PM
|
#3 |
|
Registered User
Join Date: Sep 2014
Location: The Dalles OR
Posts: 123
|
Re: Starting up a rebuilt 350 motor for the first time
Thank you Rich.
|
|
|
|
|
02-12-2016, 12:30 AM
|
#4 |
|
Senior Member
 
Join Date: Jul 2000
Location: North Texas
Posts: 3,465
|
Re: Starting up a rebuilt 350 motor for the first time
If the engine has a flat tappet cam, it's a good idea to add a can of break-in lube like CompCams #59. Or better yet, 5 quarts of a true break-in oil like Joe Gibbs Driven BR30.
__________________
Mike 1969 C10 LWB -- owned for 35 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes. 1982 C10 SWB -- sold 1981 C10 Silverado LWB -- sold, but wish I still had it! 1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming. Retired as a factory automation products salesman. Worked part-time over the years for an engine builder and a classic car repair shop. Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then! |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
