|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
04-12-2016, 11:23 PM
|
#1 |
|
Registered User
Join Date: Feb 2010
Location: gresham oregon
Posts: 806
|
Re: Project U S Army Sargent Slam
Temperary ignition switch panel is in. Just have to clean up the wiring and put it in some plastic wire loom.
Last edited by fredscarryall; 04-12-2016 at 11:42 PM. |
|
|
|
04-12-2016, 11:29 PM
|
#2 |
|
Registered User
Join Date: Feb 2010
Location: gresham oregon
Posts: 806
|
Re: Project U S Army Sargent Slam
Having a hard time with the size fitting on the pressure line of the power steering. Thats the only thing left and its ready to fire In the truck for the first time.
|
|
|
|
|
04-12-2016, 11:35 PM
|
#3 |
|
Registered User
Join Date: Feb 2010
Location: gresham oregon
Posts: 806
|
Re: Project U S Army Sargent Slam
Installed the temperary exhaust
|
|
|
|
|
04-12-2016, 11:39 PM
|
#4 |
|
Registered User
Join Date: Feb 2010
Location: gresham oregon
Posts: 806
|
Re: Project U S Army Sargent Slam
Needed the get the exhaust tight above the bottom of the frame so it doesn't scrape. Also went with Flowmaster hp2s
|
|
|
|
|
04-15-2016, 03:09 AM
|
#5 |
|
Registered User
Join Date: Feb 2010
Location: gresham oregon
Posts: 806
|
Re: Project U S Army Sargent Slam
Got the pressure side power steering line figured out. It ended up being a 11/16 Fitting going into the power steering gear box. I installed a shut off valve. Thank God I did. I tried to start it and I end up having a short in the ignition toggle flip switch. Causing a small electrical fire. That quickly went out because of the shut off switch. It could have been a lot worse. I only have to replace about 4 wires at eight feet each and a toggle switch
Last edited by fredscarryall; 04-15-2016 at 03:20 AM. |
|
|
|
|
04-15-2016, 11:52 AM
|
#6 | |
|
Registered User
Join Date: Mar 2015
Location: Morada, CA --- (Near Lodi)
Posts: 1,443
|
Re: Project U S Army Sargent Slam
Quote:
 got a linky for that gas pedal???
__________________
My Build: 57 Chevy Pro-Street Last edited by ptc; 04-15-2016 at 12:07 PM. |
|
|
|
|
|
05-06-2016, 01:32 AM
|
#7 |
|
Registered User
Join Date: Feb 2010
Location: gresham oregon
Posts: 806
|
Re: Project U S Army Sargent Slam
Got the S10 steering column in today. I used a 2 1/2 exhaust clamp and ovaled out the holes were the factory steering wheel clamp mounted under the dash.Then I drilled a 2 1/2 inch hole on the floor board with a hole saw to get the column to the engine bay. Tomorrow I Will put in the S10 brake booster.
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
