any pictures of your trucks With 18 rims?

[BugzC10]

Originally Posted by Lancialonnie

Hopefully the picture attached, I'm not so computer savvy. I just got these torque thrusts with 235 55 front 255 55 rear nitos. Now I really need to figure out what I want to do about lowering it. Spindles or springs and shocks for now? Not sure yet.

Do a 4/6 drop with spindles & springs.

[69stepper]

Originally Posted by sdotrivers15

What all is done to the suspension on this?

CPP dropped spindles, and 3" lowered springs. I cut about 3 in of new coils to get it just right up front. Back has a C Notch, 5" spring and 2 in block. Adjustable panhand bar.

[Rod Run]

Originally Posted by 69stepper

NITTO front 255/45 and rear 295/45- lowered 5 1/2 Front and 7 rear

Love your ride height

[Lancialonnie]

Originally Posted by BugzC10

Do a 4/6 drop with spindles & springs.

I would need to notch the frame to drop 6 inches in the resr, correct?
I'm looking at the spindles now, can I do the spindles and springs in the front and drop the rear later? I want to still drive it and will need to go in steps as funding allows.

[BugzC10]

Originally Posted by Lancialonnie

I would need to notch the frame to drop 6 inches in the resr, correct?
I'm looking at the spindles now, can I do the spindles and springs in the front and drop the rear later? I want to still drive it and will need to go in steps as funding allows.

You don't have to notch with 6" drop. However, you will be limited to how much weight you can carry in your bed.
If you don't do the rear at the same time, it will look like a stink bug.

I used 4" drop springs plus blocks in the rear....You supposedly get better ride with 4 vs 6" drop springs. Also...you will need an adjustable pan bar to keep the geometry correct.

[Kennuck]

255 55 18 front 8" wide Ridlers with 4.5 B.S.
275 60 18 Rear 9.5" wide Ridlers with 5.5 B.S.