Prototype center speaker holder

[68is4me]

Originally Posted by Kyle@FTP

Thank you for the feedback. This was also another reason I chose the speakers I did. They were very shallow and seem to fit most applications.

The relief for the dash pad bolt is in the works. where is says "cut half off" on the picture, what are you referring to?

I cut a 1/2 inch off on the dash pad side to move it a little closer in effort to get speakers a littler higher. The speaker I am using which is an alpine is actually a hair shorter then the Kenwoods. 1 21/32 vs 1 11/16 only 1/32 shorter, but if the magnets are smaller on the kenwoods that would allow more room.

I would definitely buy again. The material is very easy to cut.

Thanks
Kyle