|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-11-2016, 09:34 AM
|
#1 |
|
Registered User
Join Date: Jan 2016
Location: Somerset County, NJ
Posts: 135
|
Ball joint spacer/washer question
Hello all,
Buttoning up my JW Rod Garage IFS. Final install. On the upper and lower control arms supplied, came a steel washer/spacer. Lower is thicker than upper. Not sure if these go onto ball joint first, or after as a spacer under the nut. This is probably a dumb question, but im not sure. Thanks if anyone can shed light.
__________________
"All the best, Phil" My 53 IFS air bagged Upgrade Here One of my threads for this build... http://67-72chevytrucks.com/vboard/s...12#post7662512 |
|
|
|
06-11-2016, 11:39 AM
|
#2 |
|
Registered User
 Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,203
|
Re: Ball joint spacer/washer question
They are washers that go next to the nut.
|
|
|
|
|
06-11-2016, 04:57 PM
|
#3 |
|
Registered User
Join Date: Jan 2016
Location: Somerset County, NJ
Posts: 135
|
Naturally! I put them on the ball joint studs and then tried to put spindle on.
Boy, am I an idiot! Thanks... Posted via Mobile Device |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
