mcgaughys-bell tech-djm???

[62 bigwindow]

So there is no movement in the shaft that runs through the bushings and attaches the control arms to the vehicle? Since they are not pressed in and only pushed thru with a very light amount of grease and a nut on the end. Would this not allow for that shaft to have some movement inside the new bushings?
Either way still doesn't explain to me how the truck can be almost exactly 1.5" taller and the same on both sides when installing a spring that should be 1" lower. If the issue was in the control arm bushings would I not have the same result after installing the 2" spring?
And DJM assured me they didn't send the wrong springs since they don't offer a 1" drop spring