Rockwell shifter bracket

[marshall804]

Does anyone have a picture of the shifter bracket for a Rockwell T221N transfer case. I am building a 62 K-10 4wd with sbc and a SM465 4 speed and I am going to have to manufacture a bracket for the transfer case shifter.
Thanks!

[pimpston65]

Originally Posted by marshall804

Does anyone have a picture of the shifter bracket for a Rockwell T221N transfer case. I am building a 62 K-10 4wd with sbc and a SM465 4 speed and I am going to have to manufacture a bracket for the transfer case shifter.
Thanks!

i don't have a picture, but i have an extra original bracket that was from a K10 with 4 speed. just pm me the address where you want it shipped.

[MitchFloyd]

[marshall804]

I have the bracket on the transfer case and the shift lever, but my transfer is divorced and uses a rod from the shift lever to the lever on the transfer case. The guy that had it before me made one from scrap metal and welded it to a cross member. I wanted to see what the factory lever bracket looks like and try to replicate it. Thanks!

[MitchFloyd]

ok.. I know which part your looking for. I can get a pic for you later. Also, If your looking for a complete setup for backup purposes..I saw one on craigslist (DFW)

[marshall804]

Thanks Mitch. I actually have two complete transfer cases. Not sure yet about the condition of either one. The truck wasn't running when I purchased it, but it had an extra complete transfer case setting in the floor board, plus an extra case with a few parts in it.

[pimpston65]

so do you need the bracket that holds the shift rod on the trans or the transfer case? i have the bracket with the swivel point for the shift rod that attaches to the trans...