Bleeding Power Steering w/Hydroboost???

[Shibbershabber]

Okay.

So I took the rubber line from the HB (which goes to pump) and with one end in a bucket I pumped the brake until a steady stream came out upon releasing the pedal.

I reconnected it, topped off the reservoir and began turning the wheels lock to lock slowly.

Sounded pretty good, so I checked the level and went for a drive.




Stopping felt fine, though later in the trip I did notice the humming when applying the brakes and the steering was a little whiny BUT seemed to operate okay.

Was I supposed to plug the opening at the pump where that HB line went to? Was it sucking air when I was shooting into the bucket?

Or do I just need to keep turning the wheel back and forth?

Thanks