|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-13-2016, 01:37 PM
|
#1 |
|
Registered User
Join Date: May 2013
Location: Bend, Oregon
Posts: 75
|
I need a fleetside bed owner favor please......
I need to know the length center-to center hole of the fleetside bed fender support rods. I am going to make them, but I need to make sure to place the fender edges in the correct place. The fronts should measure the same and the rears should measure the same so I need both measurements. Thanks to whomever takes the time to do this for me. I appreciate it greatly.
|
|
|
|
11-13-2016, 01:48 PM
|
#2 |
|
Registered User
Join Date: Sep 2010
Location: Winchester Oregon, formerly Vancouver BC
Posts: 2,949
|
Re: I need a fleetside bed owner favor please......
Its 16" from center to center, that is with them bent already. I have one I can send you so you can see , as long as you send it back.
|
|
|
|
|
11-14-2016, 01:28 AM
|
#3 |
|
Registered User
Join Date: May 2013
Location: Bend, Oregon
Posts: 75
|
Re: I need a fleetside bed owner favor please......
That's all I need. Thanks brother! I appreciate you taking the time to help me out.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
