|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
12-09-2016, 10:54 PM
|
#1 |
|
Senior Member
 
Join Date: Feb 2010
Location: Falls City, Nebraska "100 Miles From Nowhere"
Posts: 2,219
|
Re: Did I just get a spun cam bearing?
Judging from the video your belts are a size too small. Replace your belts with a set that fit flush or just above the outer edge of the pulley's. While the belts are off, take the time to clean the pulley's and if that slipping belt polished the inside of the pulley, use a file to deglaze the shine and burnt rubber. Once a belt slips inside of the walls of a pulley, it's just a matter of time before it looses it's grip and over tightening will only wear out alt. or power steering pump bearings... http://www.bdi-usa.com/FileUploads/C...e_posters_both[0].pdf
__________________
Michael of the clan Hill, "Two Seventy Two's" 71 1-ton Dually 350 4-Speed 71 C/50 Grain Truck, 350 Split-Axle 4-Speed 02 3/4 ton Express 14 Indian Chief Vintage 1952 Ford 8N, "Only Ford Allowed On The Property"  "Be American, Buy American" 
Last edited by Ironangel; 12-09-2016 at 11:06 PM. |
|
|
|
| Bookmarks |
| Tags |
| bearing, cam, spun |
|
|
Hybrid Mode
