warn winch bumper

[52napco]

Are u interested in selling this ??

[midniteblues]

Originally Posted by 52napco

Are u interested in selling this ??

At this time no.
I have been in collecting mode for my k 20 for a while and this became part of the collection for it.

Will I use it? Well that's up in the air yet.
As I'm gonna see if I can make it work with the 71 grill guard and tow hooks.
If i can't then perhaps I'll sell it when i start selling off my hoard of parts that I won't be useing.

Just posting this since a few members asked for sizeing,just hope everyone can follow along with my mumbo jumbo.

[midniteblues]

Ok so we have.
A 1/4" thick center plate at 16 3/4" x 28" .
With a 90 degree angle in it with a 7 3/4" leg (bottom) and 8" leg for the fair lead face.

Two peices of 1/4" thick 1 1/2" x 5" c channel at 23 1/2" long.

This gives an overall length of Just about 74" considering the channels are at about a 10 degree angle from the face plate which is where the give or take 1" went.


Two 1/4" thick peices of 2 1/2" x 3 1/2" angle @17 3/4" long.


There is two 1/4" thick 1" wide x 7" long braces for the face.
I'm gonna guess these are set up and welded on spec for warn winches if you don't use a warn these could vary in placement..

Also two 1/4" x 1 1/2" 12" long straps that run at a angle from the channel too the center plate too support the channel ends.

Keep in mind this is not the normal c channel with the tapered "c" ends like I beam would have but looks too be all steel bent on a brake or stamped.
Same as the angle peices it is not "angle iron" so we used too call it. It is "braked" or "stamped".

I didn't lay out any drilled holes for the fact that most of them would be pretty explanatory once lined up with a truck or "your winch.
But if anyone would like I will get lay outs for them also.

I worked in a steel shop for a good while sawing and machining all kinds of steel and usually peices like these were all bent on a huge brake press.

If there is anything I missed or anything else please ask.
I will try.

[jerry moss]

i have the warn winch bumper but no mounting brackets, thanks for posting the dimensions of them.