LS1 Bagged 52 Chevy 3100 Build

[Bagged3100]

Yes Servicing the valves will be a little tricky without a jack, but its turning out a lot of this truck is not going to be maintenance friendly. Just no room to put anything with this setup.

I finished up running all my lines for the hydroboost

[Bagged3100]

Next up, ELECTRICAL! I started out with mounting the ECM. Using the stock harness I was very limited on places to mount it due to the length of the wires. I could mount it under the dash but it would have looked really crappy in the engine bay with the way the wires would have had to been run. And i didn't want to mount the ECM on the fire wall above the engine just because it would clutter up the firewall and not be as clean as i am hoping for. So the next best option was on the lower firewall right in the wheel well. I made the metal mounting brackets from scrap metal from building my bedsides and will be boxing it in and sealing it for a water proof seal

[reaper71]

moving along...looking good

Mark...

[steve aleve]

Bagged3100,

The truck is looking great! I have a question about your wheels. Are these 20" wheels? I love the look of them!

[NickL]

Originally Posted by Bagged3100

Also finished up my steering shaft, and made a support to keep everything lined up and working smoothly. Im pretty happy with the way everything turned out

Any way I could get a parts list for what this is made up of? I'm about to make mine for my LS/S10 3100 truck and have an idea but would like to compare it to someone that has done it.

[ClevsChev]

Any updates on this? Been looking forward to seeing more on this