How to swap your sealed 7" to LED

[Hart_Rod]

Originally Posted by lower50's

It's always a good idea to have fused circuits even if is higher amp than the draw.

Agree 100% on all your circuits being fused. And just in case I wasn't clear, I didn't mean not to use any fuses, I just mean to drop the standard headlight fuse down from 30A to 20A.

Also, are you worried that the rubber seal around the bulb will get hot and melt? I know the heat sink of the bulbs get pretty hot. Here's a picture of mine installed. Thanks again for all of the info!

Here's the lights I purchased:

http://www.ebay.com/itm/322177905990...AIT&rmvSB=true