Wiring help for Power Door Locks - Aftermarket remote

[dave_A]

FYI for all 1988-95 trucks in order to remove the door handles the service manual states to remove the window regulator and window assembly
but there is a much easier way unbolt the door latch (T30 torx) bolts (3)
and let it drop it, will fall 3/4 inch and now you can remove handle
(found this on YouTube)
and once the handle is out you can spray the latch assembly with WD-40
it did wonders.

also in order to do LH side emergency roll down, the relay has to be inside
the door frame and a extra wire has to be ran out the dust boot from door to cab, then GND the wire (relay coil-) to roll down window

the RH side is a lot easier all wiring can be done from inside the cab
trying to decide what way to go?