|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-15-2017, 06:48 AM
|
#1 |
|
Registered User
 Join Date: Apr 2014
Location: Waterford MI
Posts: 155
|
Truck starting in drive
Hi Guys
I have a 69 2 wheel drive that I did a 5.3 swap with a 4l60E trans swap. Been working on getting the little items all to work right. Got the back up lights working, had to install a new neutral safety switch. The truck starts in Park, neutral and Drive! Have tried to make adjustments but so far no luck on that fixing the starting in drive issues. Any suggestions? Thanks Mike |
|
|
|
06-15-2017, 09:25 AM
|
#2 |
|
Registered User
Join Date: Dec 2009
Location: Independence Mo
Posts: 4,119
|
Re: Truck starting in drive
Are you using the factory NSS on the column or the one on the side of the 4l60e?
__________________
My '72 short bed build. http://www.ls1tech.com/forums/conver...6-0-4l80e.html 5.3 swap into my RUSTY '71 C10 http://ls1tech.com/forums/conversion...71-c-10-a.html |
|
|
|
|
06-15-2017, 02:50 PM
|
#3 | |
|
Registered User
Join Date: Apr 2014
Location: Waterford MI
Posts: 155
|
Re: Truck starting in drive
Quote:
Mike |
|
|
|
|
|
06-15-2017, 02:57 PM
|
#4 |
|
Registered User
Join Date: Aug 2006
Location: Redmond, WA
Posts: 6,332
|
Re: Truck starting in drive
Disconnect the purple wire from the NSS, hook up a continuity tester (or meter), and verify that as you sweep it through its motion it goes off and on and various places.
If not, and I suspect not, then the NSS is bad. Make sure you don't have any BRANCHES in the purple wire. It's a series circuit, there are no parallel runs in it.
__________________
1970 GMC Sierra Grande Custom Camper - Built, not Bought 1969 Pontiac 2+2 427/390 4-speed Coupe 1969 Pontiac 2+2 427/390 4-speed Convertible |
|
|
|
|
06-15-2017, 03:26 PM
|
#5 | |
|
Registered User
Join Date: Apr 2014
Location: Waterford MI
Posts: 155
|
Re: Truck starting in drive
Quote:
Mike |
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
