Putting Camaro front in 55 second gen

[bowt1ed]

Originally Posted by Dave0

Back on it!

Several people asked to see my Trans cooler when mounted, here it is. Made a regular shroud for the engine fan.

Dave, was just looking back through this thread. Did you run your trans cooling lines through radiator, then trans cooler? Wondering if this approach will cool as effective as mounting trans cooler in front, using radiator fan.

Thanks, Jim

[dsraven]

what did you use for the light strip? does it screw onto the adapter you fabbed up?

[Dave0]

Originally Posted by dsraven

what did you use for the light strip? does it screw onto the adapter you fabbed up?

The light is out of a Toyota camry spoiler. Its a tight fit, so tight I drilled to 1/8 holes in the back to push it out if needed. I put a piece of double sided tape on it before I put it in too...

Edit, the light was givin to me. Thats all I know about it other than the word CORD embossed on one end of it. I would like to find another one...

Its stupid bright! LOL

I found one on ebay 25 bucks. I bought it. It had these stupid tabs on it but I ground them off....

[Dave0]

Originally Posted by bowt1ed

Dave, was just looking back through this thread. Did you run your trans cooling lines through radiator, then trans cooler? Wondering if this approach will cool as effective as mounting trans cooler in front, using radiator fan.

Thanks, Jim

No I didnt.... I just didnt want the extra lines up front. I'm going to monitor the temps, if its on the warm side, will either run another cooler or one bigger one.

[Bobbyh68]

Dave nice work!
Your 3rd break light housing, did you carve the base out of foam? Looks Factory!
I cant tell from the pics, can you give me more details.

Bobby

[Dave0]

Originally Posted by Bobbyh68

Dave nice work!
Your 3rd break light housing, did you carve the base out of foam? Looks Factory!
I cant tell from the pics, can you give me more details.

Bobby

Hdpe plastic 1 1/2 by 2 inch bar....

Thanks!