![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
![]() Join Date: Apr 2014
Location: MD
Posts: 26
|
![]()
So I have a 1972 c10 short bed. The engine is a 350 in the I6 position and a muncie 4 speed. The truck will also be lowered. I'm looking for a header preferably mid length that will fit also not interfere with the Z bar. From what iv read the headman header part number 69010 and 69020 will fit but I haven't heard anything about it fitting with a manual trans. Would like to know what your using and if it fits with a 4 speed. Thanks
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Sep 2017
Location: Boiling Springs NC
Posts: 1
|
![]()
Sorry to revive a thread from the dead.
I'm in the same situation. 69' c10 with 350 in the 6 cyl location and a muncie 4 speed. I'm not lowering the truck but the long tubes I'm using now come out well below the rails. Anyone used the Hedman 69010 with this setup? ![]() |
![]() |
![]() |
![]() |
Bookmarks |
|
|