Sway Bar mount

[NoNeck]

As for the tightening, you may find a torque spec on CPP site or elsewhere. If not, just tighten real snug but don't crush the rubber bushings at either end of the end link.

You should tighten the end link bolts just enough to compress the rubber bushings out flush with the edge of the gold washers but no more.

POP

[Swedchevy67]

Originally Posted by NoNeck

You should tighten the end link bolts just enough to compress the rubber bushings out flush with the edge of the gold washers but no more.

POP

Yes I believe I did that. At least it's looking fully tight.
Posted via Mobile Device